![]() ![]() This rail needs a cope cut on each end as well as a stick cut on both edges. The 67″ panels and door require a centre rail for support. The right side will be a door which is built in the same style and using the same methods. The front will be a fixed glass panel frame as will the left side. The door and two fixed glass frame panels (R) and (S) are made with a cope-and-stick router bit set. Finally, sand both posts to remove any saw marks. This will ensure that each arc is centred on the angled faces of the posts. In other words, run the opposite side of each post against the guide bar during the last cut. Check both edges after each pass and, when one edge is at 3/8″, reverse the direction of feed. The cut is at the correct depth when the remaining edges of the angled faces are 3/8″ wide. Repeat this procedure by raising the blade slightly and making slow passes across the blade. Raise the blade 1/16″ and make the first pass on each post. ![]() Any error in positioning will be corrected during the final pass. ![]() ![]() Lower the blade and hold the post centre line to the blade centre line while positioning and locking the guide bar in place. Find the centre of the angled face on each post and draw a line. Follow the alignment procedures because some saw blades travel in an arc, as opposed to straight up and down, as the blade is raised.įirst, set the blade 1/4″ above the table and draw a reference line at the blade’s centre. The post must be centred on the saw blade for the final cut to produce the correct cove cut. This guide bar is clamped in place and correctly position with the mitre slide set at 30 degrees. The angled face of each post is passed over the saw blade against a guide set at 30 degrees. If the furniture in your house is old world traditional or sleek and modern, look closely at the decorative wood details so you can duplicate them on your cabinet. Investigate the style of your existing furniture to determine the final look of your curio cabinet project. Subtle style changes in the trim can give the cabinet a totally different look. I’ll discuss the many style options available to trim your curio cabinet. If you haven’t yet purchased a cope-and-stick bit set, this project is a good reason to buy them. This is a common method used to create frames for glass doors and proved to be just as suitable as a fixed panel frame. The solution was to use a “cope-and-stick” style panel – two would be fixed and the third would become a door by installing hinges. The next issue I faced was finding a safe design to support large glass panels. It looks complicated but, in reality, making the curved posts is a simple woodworking procedure. I believe I’ve solved the “big and bulky look” buy creating a concave face on each post. But, square posts would not be very appealing and would look bulky. I decided to start with two solid 2×2 pieces of hardwood for the front corner posts. There is a great deal of glass involved and it must be properly supported. #Wood curio cabinets how to#One of the design challenges with a delicate project like this curio cabinet is how to make it sturdy while maximizing the display area. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |